ALLIS CHALMERS D10 PARTS

AC Miscellaneous - Power Unit: 60H (Power Unit - (Gas Engine SN: 53977 & up) and (Distillate Engine SN: 55480 & up). Note, Serial number is stamped at the top edge of left rear flange of block.), B125 (Power Unit - (Gas Engine SN: 4797 & up)...

Allis Chalmers - B SN B-101 and up, IB, C, CA, D10 up to SN 3501, D12 up to SN 3001 and D10, D12 both SN 9001 and up2 used per tractor, sold individually.Seal IncludedReplacement for: 70228459, 70209925, 70209983, 70209984, 70207365, 70209926

Allis Chalmers - D10, D12, D14, D15, I40, I60, I400, I600 (Gas/LP) with G138, G149, G160 enginesReplaces - 227635, 232334, 255296, 70255296  

Allis Chalmers - B,IB, C, CA, D10, D12Replacement for 70207278, 70215478, 7024310813-1/8" O/A length, 1/4" tube O.D., 1/4" compression fittings. May have to trim to fit.

Allis Chalmers: Fits the following with standard pan style seat: (D10 SN 2267 and up), (D12 SN 2242 and up), D14, D15, D17, D19, D21, 170, 175, 180, (185 up to SN 6559), 190, 190XT Industrial: I60, I600, 615, 616, 622, 801, 802 1.043 long, 1.015...

Allis Chalmers - B, IB, C, CA, RC, D10, D12, D14, D15, D17, H3, WC, WD, WD45, WF, 170, 175, I400, I500, I600 Use with our Electronic Ignition Kits ACR3189 or ACR5102 Fits 4-cylinder models listed above.   Graphite carbon core Premium united...

Allis Chalmers: D-Series using choke lever rod 1/4" - 20 Thread - 1" diameter

Allis Chalmers - D10 (wi/ 5 bolt front hub SN: 3501 & up and High Clear up to SN: 3501), D12 (wi/ 5 bolt front hub SN: 3001 & up and High Clear up to SN: 3501), D14 (with 5 bolt front hub, Wide Front Only), D15 (wi/ 5 bolt front hub up to SN:...

Allis Chalmers - B, IB, C, CA, WC, WF, WD, WD45, WD45 Diesel, D10, D12, D14 Power Unit - B125, 60H, G-138, G-149, G160, W201, W226 Replaces - 70235812, 235812 Used for governor / choke / throttle control and as hydraulic hand control depending on tractor...

Allis Chalmers: D10, D12, D15, D17, D19, D21, 160, 170, 175, 180, 185, 190, 190XT, 200, 210, 220, 5040, 6040, 7030, 7040, 7050, 7060, 7080AveryCaseCockshutt: Cockshutt MODELS with SEALED BEAM COMBO TAIL LIGHTIH / Farmall: Following with 12 Volt system -...

Allis Chalmers - Fits various models Hydraulic Lever & Brake Release Knob 1-1/4" Diameter, 3/8" - 24 Thread

Allis Chalmers - variousCase - variousCockshutt - various Ford - various International - various John Deere - various Massey Ferguson - various Massey Harris - variousMinneapolis Moline - various Oliver -various 2 terminal style -Reduce voltage - 4 OHMS...

Allis Chalmers - D10, D12, D14, D15 Thermostat Housing Gasket Replaces: 70228125, 228125

Allis Chalmers - SOME - WC, WD, WF, B, C, CA, D10, D12, IB, RC Case - SOME - R, RC, S, SC, SC-3, SC-4, SI, SO, 300, 310, 311, 312, 310B, 311B, 312B, VA, VAC, VAC-11, VAC-12, VAC-13, VAC-14, VAE, VAH, VAI, VAIW, VAIW-3, VAO, VAO-15, VAS (Using ZENITH...

Allis Chalmers: Engine Oil Filter: D15 (Gas or LP), D17 Gas or LP (SN:24001 & up), 170 (Gas or Dsl), 175 (Gas or Diesel), 510 Gas or LP, 512 Gas or LP, 500, 600, 610, 612, 614, 621, 615, I-60, I-600, 715 Dsl Hydraulic Oil filter: D10, D12, D17, D19...

Allis Chalmers - Various Case - Various Cockshutt - Various Ford - Various International - Various Massey Ferguson - Various Massey Harris - Various Minneapolis Moline - Various Oliver - VariousThis switch is a 30 amp Push / Pull switch , 3/8" diameter...

Allis Chalmers - D10, D12, D14, D15, D17, D19, ED40, 190, 190XT, 200, 210, 220 Replaces - 70918548 Set of 4 Screws

Ignitor Delco fits 4 Cylinder appilcations with 12 volt negative ground Electronic Ignition Conversion Kit will replace your points and condenser with a breakerless solid state high performance electronic ignition system that fits entirely under your...

Allis Chalmers - D10, D12, D14, D15, WD, WD45 Seal for Rear Axle Out Board of Bull Gear (Axle Hub) Replacement for: 70218284, 218284

Allis Chalmers - G, B, C, CA, IB, RC, WC, WF, WD, WD45, D10, D12, D14, D17 (up to Series III) AC Misc. - G226 Power Unit, G138, G149, G160, W226 Replacement - 70203899, 203899, 70203899V Oil Filter Tube Element Stand Pipe