Exhaust

Allis Chalmers - D21, 210, 220, 4W-220, 7030, 7040, 7045 (sn 70-20417 & up), 7050, 7060 (sn 70-20414 & up), 7080, 7580, 8030, 8050, 8070 Gleaner Combines - N5, N6, R5 Replaces - 6 x 74027014, 74025781

Allis Chalmers - 160 (Perkins Diesel), 6040 (Perkins Diesel) Muffler - Vertical Exhaust Inlet I.D. - 1 11/16" Outlet O.D. - 1 3/4" Overall Length - 35" Shell Diameter - 4 1/4" Round Shell Length - 19 3/4" Replaces - 70207310, 207310

Allis Chalmers - 4W-220, 7030, 7040, 7045 (sn 70-20417 & up), 7050, 7060 (sn 70-20414 & up), 7080, 7580, 8030, 8050, 8070 Gleaner Combines - N5, R5 Replaces - 74036827, 74036799, 74036828 3 Piece Exhaust Manifold Gaskets not included  

Allis Chalmers - 190XT (W/ Diesel Engine 1964-1973), D21 (W/ Diesel Engine 1963-1969), 190 (Gas) Replaces - 70243284, 70244555 Black finish. Inlet and outlet ID: 3", O/A length: 40"

Allis Chalmers - 7030, 7040, 7045, 7050, 7060, 7080, 7580, 8030, 8050, 8070, 4W-220 Gleaner Combines - L, L2, M, M2, N5, N6 Replaces - Center Exhaust Manifold Part # 74036828, 74036503

Allis Chalmers - D19 Gas Manifold Stud Set - Studs and Brass Nuts

Allis Chalmers - 170 Diesel, 175 Diesel Replaces - 70250049 Muffler - Vertical Exhaust Inlet I.D. - 2 3/8" Outlet O.D. - 2 1/4" Overall Length - 34" Shell Diameter - 4 1/4" x 9" Oval Shell Length - 16 1/4"

Allis Chalmers - D15 Diesel, D17 Diesel Muffler Mounting Gasket Replaces - 70229678

Allis Chalmers - WC, WF Fits AC-085D Manifold with 45 degree side exhaust. Pipe needs to be tapped into manifold using a block of metal to keep from damaging the end of the pipe; "Tight Fit". Also you can heat up the pipe or cut slots about 3/8" long and...

Allis Chalmers - (Both up to eng. SN 106509; Unstyled & Early Styled): WC, WF Replaces - 70229940, 229940, 70203178, 203178 Manifold 45 Degree Side Exhaust Gas Version. Exhaust goes out the left side of hood instead of straight up through the hood...

Allis Chalmers - D17 (Series III/IV - Gas/LP SN: 32001 & up), D19 Gas, 175, 170 (Gas); Replacement for 70234541, 234541 1-1/2" pipe thread, 6" length (Must cut down to fit your tractor) Works on OEM manifolds and DJS # AC-081D

Allis Chalmers - D17 Gas & LP SN 32001 - 42000 1 15/16" Inlet I.D. - 2" Outlet O.D. - 29" Overall Length - Use ACR1800 Rain Cap Replaces - 70234494, 234494

Allis Chalmers - (Gas & Non-Turbo Diesels from SN 19001) 190, 190XT Stanley Muffler - Vertical Exhaust - 2-3/8" Inlet ID, 2-1/2" Outlet OD, 50" Overall Length Use Raincap ACR1802 Replaces - 70250632, 250632

Allis Chalmers - 170 175 Diesel Exhaust Manifold Elbow Gasket - OEM AGCO Brand Replaces - 4223085M1, 70251239, 251239

ALLIS CHALMERS - D19 DIESEL MANIFOLD GASKET 70277124

ALLIS CHALMERS - WD45, WD45 DIESEL, D17 UP TO S/N 3200 *MAY ALSO FIT WC, WF, WD IF USING OUR AFTERMARKET MANIFOLD AC-004D   HIGH TEMP PAINT 31 1/8" - OVERALL LENGTH 11" -  OUTLET LENGTH 1 3/4" - OUTLET O.D. 20 1/8" - SHELL LENGTH 3 1/4"...

ALLIS CHALMERS - WD45, WD45 DIESEL, D17 UP TO S/N 3200 *MAY ALSO FIT WC, WF, WD IF USING OUR AFTERMARKET MANIFOLD AC-004D   POLISHED 304 STAINLESS STEEL 31 1/8" - OVERALL LENGTH 11" -  OUTLET LENGTH 1 3/4" - OUTLET O.D. 20 1/8" - SHELL...

Various Models Raincap Painted In High Temp Paint To Match Restoration Muffler Muffler Part # AC-3156D This raincap fits mufflers and exhaust pipes with 1.500" to 1.600" O.D. range

ALLIS CHALMERS - 190, 190XT, 200, 7000, 7010, 7020, 8010 GLEANER - G, L, L2, L3, M, M2, M3 Replaces - 74020090 AGCO BRAND (SOLD INDIVIDUALLY)

ALLIS CHALMERS - 180, 185, 190, 190XT, 200, 7000, 7010, 7020, 8010 GLEANER - G, L, L2, L3, M, M2, M3 Manifold gasket set 4 piece. Includes 3 (74020090) and 1 (74028190, 74025781) used with tractors with D2900 engine.  

ALLIS CHALMERS - 190, 190XT, 200, 7000, 7010, 7020, 8010 EXHAUST MANIFOLD FOR TRACTORS WITH D2900 ENGINE 74007652

ALLIS CHALMERS - 7030, 7040 TURBO OIL DRAIN TUBE GASKET OEM AGCO 70277202, 277202  

ALLIS CHALMERS - D19, D21, 190, 200, 210, 220, 7000, 7010, 7020, 7030, 7040, 7050, 7060 TURBO ELBOW GASKET FITS OUR TURBO ELBOW AC-088D, AC-307D, 70267640 5.090 O.D. X 3.100 I.D. 4 HOLES .480 DIA  .063 THICK ( DOUBLE CHECK YOUR...

ALLIS CHALMERS - 190, 190XT 190XT III, 200, 7000, 7010, 7020, 8010 EXHAUST TURBO MANIFOLD GASKET USING D2900 ENGINES 74028190

ALLIS CHALMERS - 160, 6040 Replaces - 72074033, 1865534M1 EXHAUST PIPE ELBOW 3 HOLE MOUNTING  S/N 0143044 & UP may need hood fit adjustments on 160

Allis Chalmers - D15 Diesel (up to SN 9001), D17 Diesel (up to SN 38964) Replacement - 70234493, 234493

Allis Chalmers - Early B Laser Etched Stainless Steel Manifold Plate 3" x 4-3/4", Hole Spacing 4-1/8"

Item # AC-1762D Allis Chalmers: Styled WC, WD, WD45, Early D17 gas Also fits B, C, CA, RC if you trim approximately 1" off the length and redrill one hole if needed. cross reference acs1762

Allis Chalmers - various models Case - various models Cockshutt - various models Ford - various models International / Farmall - various models John Deere - various models Massey Ferguson - various models Massey Harris - various models Minneapolis Moline...

Allis Chalmers - 160, 6040 Replacement - 72080353 Massey Ferguson - 135, 150 Massey Harris - TE20, TO20, TO30, TO35 Replacement - 4222475M1 Vertical Muffler Pipe to Manifold Gasket

Allis Chalmers - 170 Gas, 175 Gas Replaces - 70249324, 70249324V, 249324 Overall Length: 34", Shell Diameter: 4-1/4"x9", Shell Length: 16-1/2", Inlet I.D.: 1-15/16", Inlet Length: 3-1/2", Outlet O.D.: 2", Outlet Length: 14"

Allis Chalmers - 7030, 7040, 7045, 7050, 7060 Replaces - 70267640 Exhaust Elbow

Allis Chalmers - D21, 190, 190XT, 190XT III, 200, 210, 220, 6060, 6070, 6080, 7000, 7010, 7020, 7030, 7040, 7045, 7050, 7060International - 1086, 1486, 1586Chrome Curved Stack is Double Walled, 42" Tall, 4" O.D., 3" Inlet

Allis Chalmers - D10, D12 [ CA, C, B (all with thru the hood mufflers) ] Replacement - 225341, 70227240, 227240, 70233450, 233450 Dimensions of this Stainless muffler are: 1-1/4" inlet length1-1/2" inlet O.D.20-1/2" shell length3-1/4" shell diameter...

Allis Chalmers - D10, D12 [ CA, C, B (all with thru the hood mufflers) ] Replacement - 225341, 70227240, 227240, 70227240, 70233450, 233450Dimensions of this painted muffler are:1-1/4" inlet length1-1/2" inlet O.D.20-1/2" shell length3-1/4" shell...

ITEM # AC1012Allis Chalmers - D10, D12**Manifold Stud Kit contains: 6 Studs: 3/8 - 16 x 3 -- 2 Studs: 3/8 - 16 x 2 -- 6 Nuts: 3/8 - 16**

Allis Chalmers - Late D17, 170 Gas, 175 Gas, G-226 Gleaner - E Combine, E Engine, EIII Combine, K Series Combine 6 pcs = 7/16-14 on one end and 7/16- 20 on one end x 4-3/4" Manifold Studs 6 pcs = 7/16-14 Brass Nuts  

ITEM # AC1415 Allis Chalmers - D14, D15 4 pcs = 3/8-16 x 2-1/4 Manifold Studs 4 pcs = 3/8-16 x 4 Manifold Studs 8 pcs = 3/8-16 Brass Nuts

ITEM # WC001 Allis Chalmers - Early WC (with side exhaust) 4 pcs = 3/8-16 x 3-1/2 Manifold Studs 2 pcs = 3/8-16 x 4-1/2 Manifold Studs 6 pcs = 3/8-16 Brass Nuts

Allis Chalmers - WC, WD, WD45, Early D17 6 pcs = 3/8-16 x 4-1/2 Manifold Studs 6 pcs = 3/8-16 Brass Nuts