Allis Chalmers Models

Allis Chalmers - D21 Replaces - 238934, 70238934 Outer Axle Seal  4.260 OD x 3.190 ID

Allis Chalmers - 180, 185, 190, 190XT, D19 This Electronic Ignition Kit fits all models with screw held caps. 12 Volt Negative Ground for Delco Distributor #'s: 1111311, 1112466, 1112472, 1112624, 1112632, 1112653, 1112662, 1112667, 1112668, 1112676...

Allis Chalmers - 7080, 8050 Late, 8070 Lower Radiator Hose Replaces - 70268974, 268974

***This fits our sediment bowl assembly ACR2406 and AB-281D. Also fit replacement glass bowl AB-124D. *** Allis Chalmers - All Models Using A Tall Bowl  Case - All Models Using A Tall Bowl Cockshutt - All Models Using A Tall Bowl JD - All Models...

Allis Chalmers - D17, WD, WD45, 170, 175 (Gas, LP with G201, G226 engines., WC, WF (Engine SN: 13665 and up; Gas, LP with G201, G226 engines.) AC Combines - E, E3 (Gas, LP with G201, G226 engines.) AC Miscellaneous - Grader: D, DG, M65 (Gas, LP with...

Allis Chalmers - WC, WD, WD45, WF Fits G201 and G226 w/ Front Thrust Bearing (Gas or LP) w/ 226526, U3986, or 226535 crankshaft and flanged front thrust bearing. 2.416" front and 2.457" center & rear 0.020" under-size main journal. Measure before...

Allis Chalmers - D15 Series II (Gas, 160 cubic inch engine) 3-5/8" Power Crater (Cupped) Pistons (4) , Sleeves (4), Rings, O-Rings, Pins, & Clips  

Allis Chalmers - D17, 170, 175 all gas, LP with crankshaft # 229022 with center main thrust bearing Replaces - 70241103, 241103, 70234177, 234177 sold as set. Measure before ordering; cannot be returned if package has been opened

Allis Chalmers - WC, WD, WD45, WF Fits G201 and G226 w/ Front Thrust Bearing (Gas or LP) w/ 226526, U3986, or 226535 crankshaft and flanged front thrust bearing. Main journal: Standard Size; sold as set. Measure before ordering; cannot be returned if...

Allis Chalmers - CA, D10, D12, D14, D15, D17, D19, WD, WD45, 160, 170, 175, 180, 185, 190, 190XT, 190XT Series III, 200, 210, 220, 5040, 5045, 5050, 6060, 6070, 6080, 6140, 7000, 7010, 7020, 7030, 7040, 7045, 7050, 7060, 7080, 7085, 7110, 7120, 7145,...

Allis Chalmers - D10 (3502 & UP), D12 (3002 & UP), D15, H3, HD3 Replaces - 247745, 70247745 9" Clutch Pressure Plate

Allis Chalmers - B, IB, C, CA, D10 (UP to 3501), D12 (UP to 3001), D14, WF Replaces - 228926, 70228926 9" Clutch Pressure Plate

Allis Chalmers - D17, D19, 170, 175 Replaces - 241255, 70241255, 70232241, 232241 11" New Clutch Disc Spring Loaded 10 Spline 11" Outside Diameter, 1-1/4" Hub - 10 Spline (SPRING LOADED WOVEN)

Allis Chalmers - D17 (Series III/IV - Gas/LP SN: 32001 & up), D19 Gas, 175, 170 (Gas); Replacement for 70234541, 234541 1-1/2" pipe thread, 6" length (Must cut down to fit your tractor) Works on OEM manifolds and DJS # AC-081D

Allis Chalmers (all Diesel) - D21, 210, 220 Replaces - 74026082 Thermostat Coolant By-pass Hose 1.375" (1-3/8") ID Hose

Allis Chalmers - D17, WD45 Basic Zenith Carburetor Kit - for Zenith #'s: 11588, 12217, 12232, 12590 Includes Gaskets, Needle, Seat, and Throttle Shaft  

Fits AB-535D Mini Alternator   3" OD, 5/8" Belt Width, 0.587" ID,  1.437" Overall Height   Also fits Denso 100211-1660 Alternator Denso - 021041-5230

Allis Chalmers - D19 Gas, CII Combine Gas, F Combine early Gas Replaces - 74513752, 74500321, 74055406, 70277110, 4513752, 4500321 1/8"-27 NPT Ports, The 2-bolt mount includes mounting gasket. The inlet is at 2 o'clock and the outlet is at...

Allis Chalmers - 7010, 7020 Upper Radiator Hose Measurements - 2.375" ID large end, 2.25" ID small end  

Allis Chalmers - [170 (SN# 7500 and up), 175 (SN# 2035 and up) Connects inlet tube to sump cover], [210 and 220 Connects the hydraulic line to the rear axle] Replaces - 70254733, 254733 Measurements - 2.7" Long, 1.46" ID large end, 1.22" ID small...