Same Day Shipping On 99% Of Orders

Allis Chalmers 180 Tractor Parts

About the Allis-Chalmers 180

The Allis-Chalmers 180 was introduced in 1967 as the larger six-cylinder partner to the 170. It was offered with a gasoline or diesel engine, power steering, and an eight-speed partial power-shift transmission.

Early material calls the tractor the One-Eighty, while later tractors carry the numeric 180 marking. It was part of the newer Hundred series that Allis-Chalmers used to move beyond the D Series, and the serial number table below follows the 180 production run through 1973.

Serial Number Reference

Serial number locations: The tractor serial number is on the left front side of the torque housing. The engine serial number is on the left side of the engine block in front of the oil filler cap.

The table below shows the beginning tractor serial number for each Model 180 year:

 

1967-1969
Model 180 year Beginning serial number
1967 1,007
1968 2,682
1969 6,094
1970-1971
Model 180 year Beginning serial number
1970 9,235
1971 10,561
1972-1973
Model 180 year Beginning serial number
1972 11,729
1973 12,447

Total production: 11,750 Model 180 tractors: 10,163 diesel and 1,587 gasoline.

Allis-Chalmers 180 Paint Reference

For restoration planning, the Allis-Chalmers 180 is listed in the Allis-Chalmers tractor paint guide with the original paint references below.

Allis-Chalmers 180 paint reference by production period
Production period Metal Wheels Disc Chassis Trim
1961 through 1977 Persian Orange 2 Cream Cream, Aluminum Persian Orange 2 Persian Orange 2

Paint placement can vary by production year, series, and equipment configuration.

Filter By

Sort By:

Display Type:
Filters
  • Roll of black 1½-inch-wide fuel tank webbing for Allis-Chalmers farm tractors, with a short strip unwound, shown on a white background.

    Allis-Chalmers Fuel Tank Webbing - Black 1-1/2"

    Allis-Chalmers
    $2.40
    3510T83
    Black fuel tank webbing sold per foot. Fits tractors using webbed insulation between fuel tank mounts and sheet metal parts.Part Number: 3510T83FitsAllis Chalmers: variousCase: variousCockshutt:...
    Add to Cart
  • Round Allis-Chalmers farm tractor voltage meter with a black dial marked 8–16 volts, white needle near 8, red warning zones, and a chrome bezel.

    Voltage Meter 8 to 16 Volt

    Allis-Chalmers
    $32.75
    VOLT12LT
    Voltage meter with 8 to 16 volt range and illuminated dial.Part Number: VOLT12LTFitsAllis Chalmers - variousCase - variousCockshutt - variousFord - variousInternational - variousJohn Deere -...
    Add to Cart
  • Five black cylindrical seat replacement pins of varying lengths arranged horizontally on a white background for Allis-Chalmers farm tractors.

    Allis Chalmers 5 Piece Seat Pin Replacement Kit

    Allis-Chalmers
    $64.75
    DJSPINSET
    5-piece seat pin replacement kit for listed Allis Chalmers tractors.Part Number: DJSPINSETFitsAllis Chalmers D10Allis Chalmers D12Allis Chalmers D14Allis Chalmers D15Allis Chalmers D17Allis Chalmers...
    Add to Cart
  • Black Allis-Chalmers farm tractor brake release knob with a round ball-shaped head and short cylindrical stem, shown on a white background.

    Allis Chalmers Brake Release Knob

    Allis-Chalmers
    $7.25
    72502132
    Brake release, parking brake knob for listed Allis Chalmers models.Part Number: 72502132FitsAllis Chalmers D10Allis Chalmers D12 (Brake Contol, POSITION & TRACTION BOOSTER CONTROL)Allis Chalmers D14...
    Add to Cart
  • Black, glossy, spherical Allis-Chalmers hydraulic lever brake release knob, shown alone against a white background.

    Allis-Chalmers Hydraulic Lever Brake Release Knob

    Allis-Chalmers
    $5.75
    K21
    Hydraulic lever brake release knob for Allis-Chalmers equipment. Fits various models.Part Number: K21FitsAllis-Chalmers - fits various modelsSpecs3/8" - 24" thread1-3/8" diameter
    Add to Cart
  • Black, round Allis-Chalmers hydraulic lever brake release knob for a farm tractor, shown against a white background.

    Allis-Chalmers Hydraulic Lever Brake Release Knob

    Allis-Chalmers
    $5.75
    K52
    Part Number: K52Allis-Chalmers Hydraulic Lever Brake Release KnobHydraulic lever and brake release knob with a 1-1/4" diameter and 3/8"-24 thread.FitsVarious models.SpecsDiameter: 1-1/4"Thread:...
    Add to Cart
  • Allis-Chalmers Delco distributor tune-up kit for farm tractors, arranged on a white background. The kit includes a metal ignition coil with a black wire, a black distributor rotor, and a breaker-point assembly.

    Delco Distributor Tune Up Kit

    Allis-Chalmers
    $13.75
    ACR1933
    Delco distributor tune up kit for Delco distributors with screw held cap.Part Number: ACR1933FitsAC Combines - F ('some' with screw held Delco distributor cap; SN: 12201 to 31400), G ('some' with...
    Add to Cart
  • Allis-Chalmers PTO oil seal, part 70241779, with a dark rubber inner lip and metal outer casing, shown against a white background.

    Allis Chalmers PTO Oil Seal 1-3/8" 70241779

    Allis-Chalmers
    $11.95
    70241779
    Allis Chalmers PTO oil seal with 1-3/8" size for listed tractor and lift shaft applications.Part Number: 70241779FitsIBBCCAD10D12D14D15D17D19170175180185190190XT190XT III200
    Add to Cart
  • Black cut-to-length spark plug wire set for a six-cylinder Allis-Chalmers farm tractor, coiled with rubber boots and brass terminals shown separately on a white background.

    6 Cylinder Spark Plug Wire Set 90 Degree Cut to Length

    Allis-Chalmers
    $21.75
    AB-326D
    6 cylinder spark plug wire set with 90 degree ends and cut to length wires. Part Number: AB-326D Fits AC Combines - A, AII, C, CII, F, F2, G, K, K2, L, M AC Miscellaneous - Cotton Picker: 622, 801,...
    Add to Cart
  • Allis-Chalmers Water Temperature Gauge, industrial water temperature meter with 130-280 degree range, with metal mounting and coiled sensor cable.

    Allis-Chalmers Water Temperature Gauge 130-280 Degree Range

    Allis-Chalmers
    $26.75
    UTG25
    Part Number: UTG25OverviewWater temperature gauge with a 130-280 degree range. Dash mount design with block fitting and chrome bezel included.Specs130-280 degree rangeDash mountIncludes block...
    Add to Cart
  • Silver Allis-Chalmers snap coupler rivet with a twisted shank and broad rounded head, shown on a white background.

    Allis Chalmers Snap Coupler Rivet

    Allis-Chalmers
    $0.65
    DJS313
    Rivet for Allis-Chalmers Snap Couplers. Used to attach springs and sold individually.Part Number: DJS313FitsAllis-Chalmers Snap Coupler applicationsNotesSold individually.Used to attach springs.Item...
    Add to Cart
  • Close-up of a metal sediment bowl assembly for Allis-Chalmers farm tractors, with a clear glass bowl, threaded metal fittings, a brass shutoff valve with wing handle, and a protective metal bracket.

    Allis Chalmers Sediment Bowl Assembly D15 D17 D19 D21 WD WD45 170 175 180 190 190XT

    Allis-Chalmers
    $34.75
    ACR2406
    Allis Chalmers sediment bowl assembly for the listed tractor models and applications below.Part Number: ACR2406Fits190XT, 190 (Gas, Dsl. Using 2.315 Long Glass Bowl)D15 (Gas (SN: 9001 & up) & All...
    Add to Cart
  • Close-up of a round Allis-Chalmers tractor ammeter with a silver bezel and white face, labeled AMPERES and marked from 60 discharge through 0 to 60 charge. The needle points to zero.

    Allis Chalmers Amp Gauge (60-0-60) 12 Volt

    Allis-Chalmers
    $29.75
    AC-1833D
    12 volt Allis Chalmers amp gauge with a 60-0-60 scale and the Allis Chalmers logo.Part Number: AC-1833DFitsAllis Chalmers - Various (Any tractors that have been converted to 12 volt system)Specs12...
    Add to Cart
  • A roll of black, 1-inch-wide Allis-Chalmers fuel tank webbing with a short strip unrolled, sold by the foot.

    Fuel Tank Webbing - Black 1" - Price Per Foot

    Allis-Chalmers
    $2.35
    3510T82
    Black fuel tank webbing for tractors using webbed insulation between fuel tank mounts and other sheet metal parts.Part Number: 3510T82FitsAllis-ChalmersCaseWhite /OliverCockshutFordInternational /...
    Add to Cart
  • A roll of tan 1½-inch fuel tank webbing with a short length unrolled.

    Fuel Tank Webbing - Tan 1-1/2" - Price Per Foot

    Allis-Chalmers
    $4.35
    3531T52
    Tan fuel tank webbing for tractors using webbed insulation between fuel tank mounts and sheet metal parts.Part Number: 3531T52FitsAllis-ChalmersCaseWhite /OliverCockshutFordInternational /...
    Add to Cart
  • Allis-Chalmers tractor radiator with a large circular cooling core, metal frame, filler cap, and hose connections.

    Allis-Chalmers Radiator for 180, 185 - ACR2155

    Allis-Chalmers
    $1,175.00
    ACR2155
    Replacement radiator for Allis-Chalmers 180 and 185 tractors. New part ACR2155. Replaces OEM part 7025327.Part Number: ACR2155FitsAllis-Chalmers 180Allis-Chalmers 185Replaces / Cross Reference7025327
    Out of stock
  • Close-up of a round Allis-Chalmers tractor brake drum with a gray riveted friction lining, large center opening, and a smaller mounting hole on one side.

    Allis Chalmers D17 170 175 180 185 Brake Drum 70237418

    Allis-Chalmers
    $129.75
    70237418
    Brake drum for Allis Chalmers D17, 170, 175, 180, and 185.Part Number: 70237418FitsAllis Chalmers D17Allis Chalmers 170Allis Chalmers 175Allis Chalmers 180Allis Chalmers 185Replaces / Cross...
    Add to Cart
  • Two gray circular brake linings with center openings and a pile of brass rivets for Allis-Chalmers D15, D17, 170, 175, 180, and 185 farm tractor disk brakes.

    Allis Chalmers Brake Lining Kit For Disk Brakes D15 D17 170 175 180 185

    Allis-Chalmers
    $39.75
    ACR2835
    Brake lining kit for disk brakes on listed Allis Chalmers models.Part Number: ACR2835FitsAllis Chalmers - D15, D17, 170, 175, 180, 185Replaces / Cross Reference70276914, 70237421, 237421,...
    Add to Cart