Same Day Shipping On 99% Of Orders

Allis Chalmers WD Tractor Parts

About the Allis-Chalmers WD

The WD brought Allis-Chalmers' two-clutch Power Control system to the row-crop tractor market when it was introduced in 1948. The foot clutch handled the main drive, while the hand-operated wet clutch let the PTO keep turning when the tractor slowed or stopped.

Built through 1953, the WD also introduced power-shifted rear wheels and used a four-speed transmission. The WD was followed by the higher-powered WD45.

Serial Number Reference

Serial number locations: The tractor serial number is stamped at the left brake cover or the left rear of the axle housing. The engine serial number is on the left-hand side of the engine near the carburetor.

The table below shows the beginning tractor serial number for each Model WD year:

 

1948-1949
Model WD year Beginning serial number
1948 7
1949 9,250
1950-1951
Model WD year Beginning serial number
1950 35,445
1951 72,328
1952-1953
Model WD year Beginning serial number
1952 105,182
1953 131,243

Total production: 146,125 Model WD tractors.

Filter By

Sort By:

Display Type:
Filters
  • Allis-Chalmers Carburetor Float Marvel Schebler Allis Chalmers B IB C CA WC WD WF D14 D15 RC, vintage brass carburetor float for Allis Chalmers tractor carburetors with visible wear and solder joints.

    Marvel Schebler Carburetor Float

    Allis-Chalmers
    $13.75
    AB-036D
    Marvel Schebler carburetor float for listed small bowl applications. Verify carburetor manufacturer number before ordering.Part Number: AB-036DFitsAllis Chalmers: B, IB, C, CA, WC, WD, WF, D14, D15,...
  • Allis-Chalmers Bullet Tail Light Gasket Allis Chalmers B C CA G WD WD45

    Bullet Tail Light Gasket for Allis-Chalmers B C CA G WD WD45

    Allis-Chalmers
    $3.00
    OL-072D
    Rubber bullet tail light gasket for Allis-Chalmers tractors. Interchangeable with the original cork gasket.Part Number: OL-072DFitsAllis Chalmers: B, C, CA, G, WD, WD45International: Super A, Super...
  • Allis-Chalmers Universal Oil Pressure Gauge (0-30 LB) - AB-004D

    Universal Oil Pressure Gauge 0-30 LB

    Allis-Chalmers
    $21.75
    AB-004D
    Universal oil pressure gauge with a 0-30 LB range for the applications listed below. Includes verified Allis-Chalmers and John Deere fitment and replacement numbers.Part Number: AB-004DFitsAllis...
  • Allis-Chalmers Delco Distributor Cap Spring Clip With Shorter Bracket, metal spring clip, bracket and screw for engine distributor

    Delco Distributor Cap Spring Clip AB-488SD

    Allis-Chalmers
    $12.00
    AB-488SD
    Distributor Cap Spring Clip AB-488SDAB-488SD is a Delco distributor cap spring clip with the shorter bracket. It includes 1 spring clip, 1 bracket, 1 screw, and 2 washers.The bracket measures .700"...
  • Allis-Chalmers Allis Chalmers Gear Shift Lever Pins, Pair Standard 70203465

    Allis Chalmers Gear Shift Lever Pins, Pair Standard

    Allis-Chalmers
    $14.75
    AC-255D
    Allis Chalmers gear shift lever pins, pair, standard.Part Number: AC-255DFitsAllis Chalmers GAllis Chalmers BAllis Chalmers CAllis Chalmers CAAllis Chalmers WDAllis Chalmers WD45Allis Chalmers...
  • Allis-Chalmers 2-Piece Rear Crankshaft Main Seal WC WD WD45 WF, image of a split circular gasket for engine sealing.

    Allis Chalmers 2-Piece Rear Crankshaft Main Seal WC WD WD45 WF

    Allis-Chalmers
    $9.75
    AC-2037D
    2-piece rear crankshaft main seal for the listed Allis Chalmers tractors and motor grader application.Part Number: AC-2037DFitsAllis Chalmers WCAllis Chalmers WDAllis Chalmers WD45 (Gas/LP)Allis...
  • Allis-Chalmers Universal 2 Position Push/Pull Light Switch, 30 Amp, industrial electrical switch with black knob and metal contacts for machinery control.

    Universal 2 Position Push/Pull Light Switch, 30 Amp

    Allis-Chalmers
    $9.75
    AB-398D
    Universal 2 position push/pull light switch for AG and light industrial equipment. This is a 30 amp switch for battery ignition systems only.Includes a plastic knob. Knob color and style may vary...
  • Allis-Chalmers Premium Distributor Cap 4 Cylinder, close-up view of black distributor cap designed for various tractors including Allis Chalmers, Avery, Case, Cockshutt, International/Farmall, John Deere, Massey Ferguson, Massey Harris, Minneapolis Moline, Oliver.

    Premium Distributor Cap 4 Cylinder for Allis Chalmers, Avery, Case, Cockshutt, International/Farmall, John Deere, Massey Ferguson, Massey Harris, Minneapolis Moline, Oliver

    Allis-Chalmers
    $18.75
    AB-6165D
    distributor cap for 4-cylinder applications.~ Brass contacts, Bakelite ~ MADE IN USAPart Number: AB-6165DFitsAllis Chalmers: D10, D12, D14, D15, D17, RC, H3, B, IB, C, G, CA, WD, WD45, WC, WFAvery:...
  • Allis-Chalmers Starter Switch Lever B CA G IB WD WD45, metal lever component for tractor starter switch.

    Allis Chalmers Starter Switch Lever B CA G IB WD WD45

    Allis-Chalmers
    $9.00
    AC-277D
    Starter switch lever for Allis Chalmers tractors.For pull rod type starter switch systems. Bare metal.Part Number: AC-277DFitsAllis Chalmers B (sn 113779 and up)Allis Chalmers CAAllis Chalmers GAllis...
  • Allis-Chalmers Thermostat 180 Degrees, metallic thermostat component with a round, flat top and a coil spring at the base.

    Allis-Chalmers Thermostat 180 Degrees

    Allis-Chalmers
    $12.75
    AB-1086D
    Thermostat 180 degrees for Allis-Chalmers D10, D12, WC, WD, and WF.Part Number: AB-1086DFitsAllis-Chalmers D10Allis-Chalmers D12Allis-Chalmers WCAllis-Chalmers WDAllis-Chalmers WFAvery RCase CCase...
  • Allis-Chalmers Headlight Reflector for Allis-Chalmers and Other Models, reflective metal vehicle headlight component

    Headlight Reflector for Allis-Chalmers and Other Models

    Allis-Chalmers
    $14.75
    AB-320D
    Headlight reflector AB-320D is interchangeable with your original reflector and measures 4 1/2" or 4 3/4" depending on how you measure.Part Number: AB-320DFitsAllis Chalmers - B, C, CA, D10, D12,...
  • Allis-Chalmers Cast Rocker Arm Support Stand WD WF WD45 D17 170 175, engine part for tractor repair.

    Allis Chalmers Cast Rocker Arm Support Stand WD WF WD45 D17 170 175

    Allis-Chalmers
    $37.75
    AC-1161D
    Cast rocker arm support stand for select Allis-Chalmers tractor and industrial applications. Sold individually.Part Number: AC-1161DFitsWD (engine sn 253200 - 253489)WF (engine sn 253200 -...
  • Allis-Chalmers Front Felt Dust Seal for Crankshaft and Wheels, black circular felt dust seal for machinery

    Front Felt Dust Seal for Crankshaft and Wheels

    Allis-Chalmers
    $6.75
    AB-270D
    Front felt dust seal for crankshaft and wheels, with the listed tractor applications below.Use the measurements and application notes to confirm fit before ordering.Part Number: AB-270DFitsAllis...
  • Allis-Chalmers Oil Fill Breather Cap With Clip for Allis-Chalmers, IH/Farmall, black metal, round with small openings and clip on top.

    Oil Fill Breather Cap With Clip for Allis-Chalmers, IH/Farmall

    Allis-Chalmers
    $42.25
    IH-406D
    Oil fill breather cap with clip. Includes an embossed "OIL" top and a copper filter element. E-coated in black and made in the USA.Part Number: IH-406DFitsAllis Chalmers: B, IB, C, CA, Late WD, WF...
  • Allis-Chalmers Allis Chalmers 6 Volt Generator Cut Out Relay Assembly 6V Case JD Oliver

    Allis-Chalmers 6 Volt Generator Cut Out Relay Assembly

    Allis-Chalmers
    $27.75
    AB-015D
    6 volt generator cut out relay assembly for the listed tractor applications. For Autolite and Delco generators with mounting tabs parallel with cut out.Part Number: AB-015DFitsAllis Chalmers: B, IB,...
  • Allis-Chalmers Magneto PUSH-PULL Ignition Switch Allis Chalmers OEM

    Magneto PUSH-PULL Ignition Switch for Allis Chalmers

    Allis-Chalmers
    $26.75
    AB-489D
    Magneto PUSH-PULL Ignition Switch for Allis Chalmers and other listed applications. This switch has 1 screw type terminal and a threaded stem measuring 3/8 - 32 UNEF.Part Number: AB-489DFitsAllis...
  • Allis-Chalmers Brake Pin Puller Removal Tool Allis Chalmers D17 WD WD45

    Brake Pin Puller Removal Tool for Allis-Chalmers WD, WD45, D17

    Allis-Chalmers
    $78.75
    AC-3558D
    Brake Pin Puller Removal Tool for Allis-Chalmers WD, WD45, WD45 (diesel), and D17 (up to SN: 42000).Part Number: AC-3558DFitsAllis-Chalmers WDAllis-Chalmers WD45Allis-Chalmers WD45...
  • Allis-Chalmers Carb Elbow and Strainer Assembly

    Carb Elbow and Strainer Assembly

    Allis-Chalmers
    $8.75
    AB-297D
    Carb elbow and strainer assembly for Allis-Chalmers and other listed tractors. New part with male end screen end 1/8" pipe thread and female end 1/4" flare.Part Number: AB-297DFitsAllis...