Allis Chalmers Models

Axle seal with dimensions of I.D. 1.187, O.D. 2.004, and width .250.Use the application notes below for inner axle seal, inner upper final drive shaft seal, differential carrier seal, and lower steering shaft oil seal uses.Part Number: AB-1628DFitsAllis...

12 volt bulb for a wide range of tractors and equipment, including Allis-Chalmers, Case, Ford, International, John Deere, Massey Ferguson, Massey Harris, Minneapolis Moline, and Oliver.Part Number: AB-345DFitsAllis-Chalmers D10Allis-Chalmers...

12-volt dash light assembly for Allis-Chalmers tractors.Chrome finish with a 0.658" socket diameter and 1" center-to-center mounting holes.Part Number: AC-273DFitsAllis-Chalmers 190XTAllis-Chalmers D10Allis-Chalmers D12Allis-Chalmers...

Clutch alignment tool for the listed tractor applications. Plastic construction with 10 spline, 15/16" spline OD, and 0.625" pilot.Part Number: AB-1437DFitsAllis Chalmers: GIH / Farmall: Cub, Cub LoBoyMassey Harris: PonyReplaces / Cross...

4.5" clamp ring with screw for select Allis-Chalmers and other applications. New condition.Part Number: JD-676DFitsAllis Chalmers: 7050, 7030, 6040, 220, 210, 200, 190, 185, 180, 175, 170, 160, D21, D15 (Late Models), 190XTCase: Lawn & garden: 224,...

Generator belt AB-103D for select Allis-Chalmers, IH Farmall, John Deere, and Oliver applications. New condition.Part Number: AB-103DFitsAllis Chalmers: Following models using 3-5/8" diameter generator pulley: U (SN: 1785 & up), UC (SN: 1785 &...

Light visor MF-108D for select Allis-Chalmers, Massey Ferguson, and Massey Harris applications. New condition.Part Number: MF-108DFitsAllis Chalmers: D10 (SN: 9001 & up), D12 (SN: 9001 & up), D15 (SN: 9001 & Up), D17 (SN: 42001 & Up),...

Part Number: AB-460D12-Volt Sealed Hi-Beam Bulb 4.365 OD12V sealed hi-beam bulb with double-contact, 35 watt output and 4.365 O.D. Verify application before ordering.FitsAllis-Chalmers: 190XT, 170, 175, 180, 185, 190 (Not original Look), 200, 6040, 6060,...

Part Number: 70237386Fan Belt for Allis-Chalmers D17, E, E3, 70237386Fan belt for listed Allis-Chalmers applications, including D17 power steering pump use. Verify belt size before ordering.FitsAllis-Chalmers: D17 (gas, SN 42001 and up - power steering...

Part Number: AB-462D6-Volt Sealed Beam Bulb 4.365 OD6V sealed beam bulb with double-contact, 25 watt output and 4.365 O.D. Verify fit before ordering.FitsAllis-Chalmers: 200, 6040, 6060, 6080, 7000, 7010, 7020, 7030, 7040, 7045, 7050, 7060, 7080Case: 770...

Part Number: AB-353D12-Volt Sealed Lo-Beam Bulb 4.5"12V sealed lo-beam bulb with double-contact, 35 watt output and 4.5" diameter. Verify application before ordering.FitsAllis-Chalmers: 190XT, 170, 175, 180, 185, 190 (not original look), 200, 6040, 6060,...

Part Number: AB-352D6 Volt Sealed Lo-Beam Bulb6 volt sealed lo-beam bulb for the applications listed below.FitsAllis Chalmers - 190XT, 170, 175, 180, 185, 190 (not original look), 200, 6040, 6060, 6080, 7000, 7010, 7020, 7030, 7040, 7045, 7050, 7060,...

Part Number: AC-1571DAllis Chalmers Thermostat Housing GasketThermostat housing gasket for the listed Allis Chalmers models.FitsAllis Chalmers - D17, WC, WD, WD45, WF, 170, 175AC Combines - E, E3, KAC Lawn & Garden - 616AC Miscellaneous - Cotton...

Part Number: AB-527DConcave Light Mounting Washer / RetainerConcave light mounting washer / retainer for the applications listed below.FitsAllis Chalmers - 190XT, 170, 175, 180, 185, 190 (not like original), 200, 6040, 6060, 6080, 7000, 7010, 7020, 7030,...

Thermostat 160 degrees with a 2.600" length and 2.510" flange diameter.Fits the listed tractor applications below.Part Number: IH-913DFitsAllis Chalmers: B (Engine SN: 126210 & up when equipped with water manifold bypass), C, CA (Engine SN: 195136...

Part Number: AB-052DThermostat w/ Gasket for Ford ModelsThermostat with gasket for Ford models only. New part with multiple tractor applications listed below.FitsAllis Chalmers - 4W220, D21, 210, 220, 6040, 7000, 7010, 7020, 7030, 7040, 7045, 7050, 7060,...

Raincap with a 3-1/2" O.D. and zinc plated finish.Fits the listed tractor applications below.Part Number: RC-016DFitsAllis Chalmers: WC, WD, WD45, D17 GAS (EXCEPT SERIES IV) - FITS STRAIGHT CHROME PIPECaseCockshutt: E4, E5, 40, 50, 560, 570 GOLDEN EAGLE...

Clutch disc for Allis-Chalmers G, IH/Farmall Cub, and Massey Harris Pony and Pacer applications.Part Number: MH-076DFitsAllis-Chalmers GIH / Farmall CubMassey Harris Pony (#11)Massey Harris Pacer (#16)Replaces / Cross ReferenceAllis-Chalmers...

New 6-1/2" clutch pressure plate for Allis-Chalmers G.Part Number: AB-550DFitsAllis-Chalmers GInternational / Farmall CUBInternational / Farmall CUB LO-BOYMassey Harris PonyMassey Harris PacerReplaces / Cross...

Clutch kit for Allis-Chalmers B, C, CA, and IB tractors. Diameter should be measured before ordering.Includes an 8-1/2" pressure plate, 8-1/2" 10 spline solid clutch disc, throw-out bearing, and pilot bearing.Part Number:...